ProCore 648

See below for more information...

The ProCore® 648 is an innovative new walking aerator from Toro®. The rear wheels are within the 48" aeration swath of the machine so the tires are not running over the freshly aerated turf. This eliminates the problem of smashing the cores into the holes, preventing topdressing from filling the holes. And easier cleanup produces a savings of time and labor.

• No Crushed Cores
• Higher Productivity
• Contour Following System
• Easy and Safe to Operate
• Deeper Holes

Innovative Rear Wheel Placement

The wheels are located in front of the aeration head so they do not drive over the freshly aerated turf and run over the cores.

Efficient Aeration

The ProCore® 648 is more efficient with a 48 inch aeration swath that is 50 - 100 percent wider than competitive units.

High Productivity

The ProCore® 648 allows you to aerate all 18 greens in about 7.2 hours* and clean up is easier and less labor intensive resulting in less time.

*Assumes average 6500 sq./ft. greens, 2"x2" linear hole spacing, 1000 feet between greens at maximum transport speed and standard "tear-drop" style turnarounds.

TrueCore™ Ground Following

The TrueCore™ sensing system automatically maintains tine depth on the fly to match the ground undulations providing consistent coring depth of up to 4".

Deeper, High Quality Holes

RotaLink™ geometry allows the tines to enter and exit the ground cleanly leaving a high quality result.

Ease of Operation

A single switch on the handle controls the tine head and a handle bail engages forward and reverse. No shifting required. A fail safe system stops the machine and lifts the coring head if bail handle is released.

Smooth, Quiet, Powerful

To give the ProCore® 648 its uncommonly smooth operation, the action of the tine arms are modeled after a six-cylinder car engine. The arms work in pairs to counterbalance the coring action. This precise configuration virtually eliminates hopping, rocking and unnecessary vibration.

Series/Parallel 3-Wheel Drive

The patented 3-wheel series/parallel traction drive, combined with high-torque, low-speed wheel motors, prevents slippage for reliable traction and even hole spacing.

Variable Hole Spacing

The ProCore® 648 gives you more control with variable hole spacing ranging from 1.5 inches to 3 inches apart.